Sky's Off-road Design - Picture Gallery

top_bar

top_bar

top_bar

top_bar

navtop_left

Welcome Guest navtop_right

navtop_right

Forum Home

Pictures

Events

Shopping Cart

Products

Home

Login
Register

Home
Products
Shopping Cart
Events
Pictures/Installs
Forum
History
Terms/Conditions/Small Print
Toyota SAS Instructions
Matt Compton Medical Fund

Q	Item
	(Empty)
Sub-Total $0.00 View Cart : Check Out

Gallery List|View Gallery Pictures / View Gallery

CHEVY SAS

Posted: 12-14-2010
Images: 11

STOCK TAHOE BEFORE SWAP
0 Comment(s)

have a plan before staring project, including getting measurements
0 Comment(s)

DANA 60 FRONT AND A 14 BOLT FULL FLOATER FOR THE REAR
0 Comment(s)

cut off all ifs mounts and sand frame
0 Comment(s)

lay out kit and dry fit hanger parts so you know where they go
0 Comment(s)

sand inside frame rails where shackle hangers go
0 Comment(s)

measure out where you want your axle to sit. i moved the axle forward 1 inch
0 Comment(s)

tack hanger in place and set onto the ground to check shackle angle. This is a weld on kit, the holes are for plug welds.
0 Comment(s)

after everything looks good finish welding all hangers and install springs
0 Comment(s)

install axle and tighten all fasteners
0 Comment(s)

this has around 8 inches of lift with 35s
1 Comment(s)

Page 1 of 1